Utility & Footing Trenching in Utah
Trenching is the narrow, deep cut that carries a water service, sewer lateral, gas line, conduit, or drain line — or the continuous footing a foundation wall stands on — to the depth the plan and the frost line require. Grandview cuts, beds, and backfills these trenches as a licensed B100 general contractor, verifiable through the Utah Division of Professional Licensing, across Utah County and the Salt Lake Valley.

When trenching is the scope, and when it isn’t
Trenching is measured in linear feet and inches of depth, not truckloads: a sewer lateral to the street, a conduit run to a detached shop, a French drain along a wet side yard, or footing trenches for a garage on a lot already at grade.
If the hole has to hold a basement, that’s foundation and footing excavation. If the whole lot has to move first, that’s mass excavation. And if the problem is water on the surface rather than a pipe that needs to be underground, regrading may solve it without a trench. The trades stack up on trench jobs — plumber, gas utility, electrician, inspector — and we see dependencies before they become delays.
What goes into a utility trench
Every utility trench starts with a Blue Stakes 811 locate, which Utah law requires before any excavation, and the invert elevations off the plumbing and electrical drawings. Then the details get service-specific.
- Depth is set by the service. Water lines go below frost depth — commonly around 30 inches along the Wasatch Front, with your city’s building department setting the number that counts. A sewer lateral is governed by fall instead: a steady slope, typically a quarter inch per foot on a residential 4-inch line, from the cleanout to the main tap.
- Separation. Water and sewer stay 10 feet apart horizontally by common standard; where they must cross, water goes above sewer.
- Bedding. Pipe never sits on raw trench bottom. We place a few inches of sand or 3/4-inch-minus, lay the pipe, then shade it with the same material 6 to 12 inches over the crown so no native rock rests on the line.
- Tracer wire and tape. Non-metallic lines get a tracer wire so the next person can locate them, plus marking tape above the pipe so a future shovel hits the warning first.
- Backfill in lifts. Native soil goes back in layers and is compacted, not pushed in from one side and driven over. Under a driveway or slab, trench backfill is density-tested like any other structural fill; a trench that settles leaves a stripe in the concrete above it for years.
Licensed plumbers and electricians under our contract place the pipe and wire; we open the trench, bed it, hold it for inspection, and close it.

What goes into a footing trench
A footing trench is a different animal. Width comes off the foundation plan — often 16 to 24 inches for a residential continuous footing — and the bottom must be level, below frost depth, and on undisturbed native soil or tested structural fill. The inspector checks exactly that before concrete goes in.
Soil decides how we cut it. In stiff valley-floor clay the walls stand clean and the footing can be poured against the earth with a screed board setting the top. On the benches, where the Utah Geological Survey maps collapsible soils and the ground is often loose gravel and cobble, trench walls slough and the bottom crumbles underfoot. There we cut wider, set forms, and hand-clean the bottom right before the pour so the footing bears on firm ground, not on what fell in overnight. Loose material, water, or frozen crust in the bottom is a failed inspection now and a cracked wall later.
Sloped lots get stepped footings — vertical steps sized by the engineer, not a slanted trench following the hill. Any sewer stub or water sleeve under the footing goes in before the pour. From there the work hands off to foundations.

What does trenching cost in Utah?
The price per linear foot is driven by depth, ground, and what’s in the way. As ballpark planning numbers only — never a quote — residential utility trenching in open ground often runs $10 to $30 per linear foot for cut, bedding, and backfill, before the pipe and the plumber. Footing trenches are usually priced inside the foundation excavation.
- Depth past 5 feet. Trench-safety rules require sloping, shoring, or a trench box once a trench reaches 5 feet deep, and a sewer lateral chasing a deep main gets there fast.
- Cobble and boulders. Wasatch Front alluvial fans are full of rounded river rock a trencher can’t chew through; the job moves to an excavator bucket and the foot price rises.
- Existing lines and hardscape. Near a marked utility the machine stops and the shovels start; a trench across a driveway adds saw-cutting and patching. Routing around both is often cheaper.
Questions we actually get
How deep does a water line have to be buried in Utah?
Below frost depth, commonly around 30 inches of cover along the Wasatch Front. Your city’s building department sets the official number. A shallower line freezes in a hard January, so we cut to the local requirement and document depth before backfill.
Can you trench through my existing driveway or landscaping?
Yes, and we’ll first ask whether we should. A patched driveway trench leaves a seam and settles unless the backfill is compacted and tested. When the route allows, we go around hardscape or under it with a short bore; when it doesn’t, restoration is priced as part of the trench.
Do you install the pipe, or just dig the trench?
We dig, bed, and backfill. Water, sewer, and gas lines are installed by licensed plumbers, and conduit and wire by licensed electricians, all under Grandview’s contract and schedule. The gas utility typically installs its own service from the main to the meter. One contract, one sequence; the licensed trades do what their licenses cover.
What happens if the trench hits rock or an old utility?
We stop and tell you first. Cobble layers mean switching from a trencher to an excavator at a slower foot rate; an unmarked private line — an old sprinkler main, landscape lighting — gets hand-exposed and rerouted or protected. Either way you hear the cost change before the trench moves another foot.
Trenching is one piece of our excavation and grading work, inside the site, structure & envelope family. Drain-line trenches often pair with foundation waterproofing; footing trenches on a bare lot usually follow building pad preparation.
Tell us what you’re working on
Send us the address and what needs to go underground, and we’ll give you a straight read on route, depth, and budget. We reply within a couple of hours during business hours, a day at most.