French Drain & Interior Drain Tile Installation
A French drain is a sloped trench of washed gravel around a perforated pipe that collects groundwater and carries it to a sump or daylight outlet; interior drain tile is the same system run beneath a basement floor along the footing. Grandview installs both across Utah County and Salt Lake County under a B100 general contractor license.

When a French drain is the right fix, and when a sibling is
A French drain solves one specific problem: water in the soil, moving slowly, arriving where it shouldn’t. A lawn that stays spongy for a week after snowmelt, a side yard that ponds every July cloudburst, a basement that seeps along the slab edge with no visible wall crack, a retaining wall weeping through its joints. The ground needs a lower, easier path.
It isn’t the fix for everything in this family. If water pools against the house because the lot tilts toward it, that’s a grading and surface drainage job first; a drain under a badly graded yard just fills faster. If water enters through the wall itself, high up and only in storms, you’re closer to interior basement waterproofing, where wall vapor management matters as much as the pipe. If the problem is hydrostatic pressure at the base of the foundation and the yard is open enough to dig, an exterior footing drain is the deeper, more permanent version of this. And a drain only works if it has somewhere to go, which is why half of these jobs end at a sump pump.
The short version: surface water wants grading, wall water wants membrane, soil water wants a French drain. Most Wasatch Front lots have some of all three, so we walk the property first and scope in order of cost.
What goes into a French drain that still works in year ten
- Locate and route. Where water collects, where it can legally leave, and what’s buried in between. Blue Stakes locates come first; sprinkler lines and gas live at French-drain depth.
- Trench to a true fall. Typically 12 to 24 inches wide and 18 to 36 inches deep, shot with a laser to a continuous slope of at least 1 percent. A level spot anywhere in the run becomes a silt trap.
- Line the trench. Non-woven geotextile wraps the whole gravel envelope, not just the pipe. In Utah’s fine clay and silt soils, unwrapped gravel clogs within a few seasons.
- Bed, pipe, and cover. Washed 3/4-inch gravel, rigid perforated PVC with the holes down, then gravel to within a few inches of grade. Rigid pipe over corrugated flex wherever the run matters; it holds its slope and can be jetted clean.
- Outlet and finish. Daylight to a pop-up emitter or dry well, or tie into a sump basin. Cleanouts at direction changes, then topsoil and sod or decorative rock.
A curtain drain is the same build placed uphill of what you’re protecting, intercepting groundwater before it reaches the house. On sloped bench lots in Alpine, Highland, and Draper it is often the most cost-effective version.

Interior drain tile: the French drain under the basement floor
Inside, the same system runs along the slab perimeter. We saw-cut and remove a strip of concrete roughly 12 inches wide along the affected walls, excavate to the top of the footing, set perforated pipe in washed gravel on the footing shelf, and run it to a sump basin. Weep holes or a dimpled mat at the base of the wall let water entering the cove joint drop into the channel instead of crossing the floor. The concrete is then patched flush.
Drain tile is the right call when the symptom is seepage at the floor-wall joint or through floor cracks, or when a driveway, deck, or neighbor’s fence makes opening the slab edge cheaper than opening the yard. It controls water that arrives; it does not stop water from touching the wall. That is the honest difference between drain tile and exterior waterproofing.
Two Utah conditions shape the design. Expansive clay and collapsible soils, mapped by the Utah Geological Survey, drain slowly and move when saturated, so the gravel envelope has to carry water laterally rather than rely on the soil. And with 100-plus freeze-thaw days a year along the Front, any outdoor outlet is sloped so water never sits in the last few feet of pipe over winter.
What does French drain installation cost in Utah?
As ballpark planning numbers, a yard or curtain French drain typically runs $30 to $75 per linear foot installed, so a 60-foot run with a daylight outlet often lands between $2,000 and $5,000. Interior drain tile around a basement perimeter, including the sump basin, usually falls in the $5,000 to $14,000 range depending on how many walls are involved.
What moves the number: trench depth and soil (rock and hardpan slow the dig), equipment access versus hand digging, outlet distance and whether it needs a pump, and how much concrete or landscape must be cut and restored. Some cities restrict draining to the street or a neighbor’s lot, so verify with your city’s public works department before counting on a curb outlet.

Questions we actually get
Can a French drain run beside a retaining wall?
It should. A retaining wall without a drain behind it carries the full weight of saturated soil, which is how walls lean. We set wrapped perforated pipe in gravel at the wall’s base and daylight it through or around the wall, during the build or as a retrofit.
Do I need a permit for a French drain?
Yard drains that stay on your property usually don’t. Interior drain tile tied to a sump, or any outlet to the street or storm system, often does; we check with the city before scheduling. Our B100 license is verifiable at dopl.utah.gov.
Why did my old French drain stop working?
Almost always silt: fabric left off, gravel with fines, a flat section, or corrugated pipe that bellied after backfill. Occasionally roots or a crushed outlet. We camera the line first; if the slope is sound we jet it, and if not we rebuild the bad section with rigid pipe and a wrapped envelope.
French drains are one piece of our waterproofing and drainage work within the site, structure & envelope family. If the wet spot is a window well, see egress window well drainage; the gravel sump under a well is a very small French drain.
Tell us where the water collects
We reply within a couple of hours during business hours, a day at most. You’ll get a straight read on where the water comes from, where it can go, and a real budget range before anyone commits.