Multi-Level Deck Builders in Utah County
A multi-level deck is two or more connected platforms at different heights, joined by short stair runs so a sloped yard or tall walkout becomes several usable rooms instead of one high box. Grandview designs, permits, and builds them in Utah County under a B100 general contractor license, with each tier on its own footings.

When stepping the deck down beats one big platform
The honest test is the grade. If the ground falls more than a few feet across the footprint you want, a single-level deck either hovers over the low end on tall posts or stops short at the high end. A multi-level deck follows the slope: an upper tier at door height, a middle tier a few steps down, a lower tier near the yard. Bench lots in Alpine, Highland, Cedar Hills, and east Provo and Orem are where we build most of them.
The second reason is use. The same 500 square feet split across three tiers gives you a dining level off the kitchen, a hot tub level, and a fire-pit level, each defined by height rather than furniture.
Flat yard, door near grade: a ground-level deck does the job for less. Door a story up over a level yard: an elevated second-story deck with one long stair is the simpler structure.
How a multi-level deck is actually framed
Most people picture one deck with a step in it. Structurally, it’s several decks that share posts. The upper tier is usually an attached deck hung from a flashed, bolted ledger at the house. Each lower tier is a freestanding frame on its own beams and posts, sharing a post line where two tiers meet so the transition step lands on solid framing, not a cantilever.
- Drop between tiers. One step between levels is a trip hazard people stop seeing after a week. Transitions are a flush change in decking or a clear run of two or three risers at a consistent height, so the eye reads a stair, not a stumble.
- Guards per tier, not per deck. Under current Utah-adopted code, any walking surface more than 30 inches above the grade beneath it needs a guard. On a slope the middle tier can cross that line while the lowest doesn’t. We map it edge by edge.
- Independent footings for every tier. Each level gets its own frost-depth footings, commonly around 30 inches along the Wasatch Front and set by your city. A tier that borrows support from the one above moves differently in winter, and the stair between them shows it.
- Inter-tier stairs as framing, not trim. Short runs get the same rise-and-run consistency as a full flight, with stringers landing on framing or a pad, never dirt. Our deck stair and railing page covers hardware choices.

Slope, soil, and snow: what the lower tiers handle
The lowest tier sits closest to the ground, so it catches what the yard sends downhill. Summer cloudbursts push a lot of water across a bench lot in minutes, and a low tier that blocks that path becomes a dam. We grade a swale or run a drain behind the lowest beam line and keep the underside ventilated.
Collapsible bench soils, which the Utah Geological Survey maps along much of the Wasatch Front, settle when first saturated, and a multi-level deck has more footings in more places to notice it. Where soil is questionable, we widen the bearing area or build a retaining wall to create a stable shelf for the lowest tier first.
Snow is the quieter issue. Drifts collect against the riser between tiers, so the lower tier carries more winter weight than the upper one, and Highland or Alpine lots see heavier loads than Provo on the valley floor. Lower-tier framing is sized for the load that will actually sit on it.
What does a multi-level deck cost in Utah County?
As ballpark planning numbers, not quotes: a multi-level deck prices above a single-level deck of the same square footage, because that figure hides the extra footings, beam lines, stairs, and railing every tier brings. Composite multi-level builds in our market commonly land around $70 to $115 per square foot installed; pressure-treated wood somewhat less. The ranges on our deck construction page are the floor for this configuration, not the ceiling.
- Number of tiers. Each level adds footings, a beam line, and a transition stair. Two tiers is a modest premium; four is a different project.
- Total railing length. Every edge above 30 inches needs a guard and every inter-tier stair a handrail. Cable or glass systems multiply fast across several short runs.
- Built-ins and lighting. Bench seating at a tier edge can double as a guard where height allows; step lights on the transitions are a circuit we coordinate through licensed electricians under our contract.
After a site walk you’ll get a tier-by-tier budget range, then a firm estimate once selections are settled.

Questions we actually get
How many steps should there be between deck levels?
Either none, as a flush change in decking, or a clear run of two or three risers. A single step is the one people trip on at night. If the grade only wants one riser of drop, we’ll usually raise or lower a tier so the transition reads as a proper stair, or flatten it entirely.
Does each level need its own permit?
No, one building permit covers the whole structure, but the drawings must show every tier, its height above grade, its footings, and which edges get guards. Inspectors check each level against the 30-inch threshold separately. We prepare the drawings, schedule inspections as one project, and verify thresholds with your city’s building department.
Can you add a lower tier to a deck I already have?
Often, yes, if the existing deck is sound. We inspect the ledger, posts, and footings first, since the new tier will share a post line with the old one. The new level gets its own frost-depth footings and frame. If the original footings are shallow or heaved, we’ll show you before building onto them.
What drives multi-level deck cost more than a regular deck?
Railing length and footings. Every tier adds perimeter that may need guards plus a stair with handrails, and every tier sits on its own footings and beams. That’s why a three-tier deck costs more than a single platform of the same area. Fewer, larger tiers are usually the most economical way to step down a slope.
Multi-level decks are one configuration within our deck construction work in the site, structure & envelope family, built under a B100 license you can verify at Utah DOPL. Problems happen. Surprises should not.
Tell us about the slope you’re working with
We reply within a couple of hours during business hours, a day at most. You’ll get a straight read on tiers, footings, and budget before anyone commits to anything.