Renovation & Build-Outs · MEP & Systems · Low-voltage

Security Camera & CCTV Installation

Security camera installation is the wired kind of surveillance: PoE camera drops pulled to the eaves and entries, a network video recorder in a locked spot, and every mount sealed against weather. It fits any Utah County home, shop, or commercial building that wants recording independent of Wi-Fi; Grandview holds the contract under a B100 general contractor license and manages the licensed low-voltage trade partners who pull, mount, and commission the system.

Discuss a project   Or call (385) 236-1741

Contemporary Utah home with glass doors and panoramic windows, the entry points a security camera layout covers first
When this is the right call

When a wired camera system is the scope, and when a sibling page fits better

This page is for cameras with cable behind them: fixed IP cameras on Cat6, a recorder storing footage on site, coverage planned around doors, gates, and approaches. If the question is sensors, keypads, and who gets alerted when a door opens, that’s alarm and access control. A single video doorbell is doorbell and intercom work. Cameras often join one of those scopes and share its rough-in.

Cameras ride on the building’s data backbone. If no Cat6 exists, structured wiring puts the home runs in while walls are open, and network and Wi-Fi infrastructure gives the recorder a switch worth plugging into. Battery and Wi-Fi-only cameras skip all of this, and also skip reliable overnight recording in a Utah January, when lithium cells lose capacity and a 2.4 GHz signal through stucco and foam drops frames.

The best timing is any project with framing open: a new build or ADU in Lehi or Eagle Mountain, a walkout basement finish, a detached shop, or a tenant improvement. Retrofits work too; the cost shifts from cable to attic access and exterior conduit.

What the work involves

How a camera system is laid out, wired, and commissioned

  1. Coverage map first. We walk the property and mark camera locations: each exterior door, the driveway apron, the garage man-door, side yards, any gate. Each camera gets a purpose (identify a face, read a plate, or watch an area), which sets the lens, height, and resolution. A face at a front door needs a camera within 10 to 12 feet; a driveway overview can sit at the eave.
  2. Pick the platform. PoE IP cameras on one Cat6 run each are the default: a single cable carries power and video. HD-over-coax is still right where good RG6 already exists in an older Provo or Orem home. Brand and recorder channel count get locked before rough-in so the cable count matches the hardware.
  3. Place the recorder. The NVR goes somewhere locked and ventilated, usually the mechanical room, never a closet that hits 100°F in July. It needs a dedicated receptacle, a network drop, and drive capacity for 30 days of retention at the chosen resolution.
  4. Rough-in with the electricians. One home run per camera, Cat6 inside, UV-rated cable or EMT conduit on any exposed exterior path, ending at a junction box behind each camera so no connector sits in the weather. Wasatch Front sun at 4,500 feet turns unrated jacket brittle in a few seasons; it’s the detail that fails first on cheap installs.
  5. Mount for the weather. Cameras go under eaves or soffits where snow can’t pile on the lens and dawn sun isn’t in frame. Housings are rated for valley winter lows and every penetration through stucco or siding is gasketed. On bench lots in Draper, Alpine, and the Centerville corridor, mounts fasten to framing, not sheathing, because canyon-wind gusts loosen anything less.
  6. Commission and hand over. Every camera is aimed on a monitor, time-synced, and set for motion zones and night mode. You get a labeled map of which channel sees what.
Chain-link perimeter fence, the kind of gate and property line a security camera layout covers
Commercial & multifamily

Camera systems for shops, tenant spaces, and apartment buildings

Commercial work changes the count, not the method. A shop in Lindon or West Valley City wants dock doors, the yard, the cash area, and an overview of the floor; multifamily wants stairwells, parking, mail rooms, and every exterior door, with the recorder in a locked telecom room. They usually share rough-in with commercial access control, so readers and cameras use the same conduit and network closet.

Cable length matters more here: Cat6 is good to about 328 feet, so a long building gets a second PoE switch or a fiber link. Each low-voltage partner’s license, and ours, is verifiable at dopl.utah.gov.

Multi-story apartment building exterior where camera coverage focuses on entries, parking, and stairwells
Cost drivers

What does security camera installation cost in Utah County?

As a ballpark planning number, a four-camera PoE system with a recorder, wired during a build or remodel, typically lands around $1,500 to $4,000 installed. Eight to sixteen cameras with a larger NVR, exterior conduit, and retrofit fishing in a finished home or small commercial space more often runs $5,000 to $15,000. Hardware is roughly half; cable access is the rest.

What moves the number: open versus finished walls; camera count and resolution (4K needs more storage and a faster switch); exposed exterior paths that need conduit; brick or block exteriors with no framed cavity; and days of retention on the drives. Plate-reading and pan-tilt-zoom cameras cost several times a fixed dome. None of these are quotes; after a walk-through we give a budget range, then an estimate once the camera map and brand are settled.

Questions we actually get

Can cameras go in before I’ve picked a brand?

Yes, once the platform is decided. If it’s PoE, one Cat6 home run to each marked location, with a box behind it, serves nearly any IP camera sold today. Camera count and recorder location must be fixed before rough-in; the specific model can wait until trim.

Do I need to open walls in a finished home?

Usually not for eave-mounted exterior cameras: Cat6 is fished through the attic to the soffit and dropped to a recorder in the basement or garage. Interior cameras below a finished floor, or runs through a brick exterior, are where a small drywall patch or exterior conduit becomes the honest answer.

Does footage go to the cloud, and who can see it?

With a wired NVR, footage stays on drives in your building, and remote viewing runs through the recorder’s app. Cloud backup is optional and carries a subscription. The camera network is isolated from your main Wi-Fi so a camera firmware flaw can’t reach your laptops, and unique passwords are set before handover.

Tell us what you’re working on

Camera systems run inside our MEP and systems coordination and the broader renovation and build-out work. We reply within a couple of hours during business hours, a day at most, with a straight read on camera count, cable path, and budget.

Request an estimate   (385) 236-1741