Air Sealing & Weatherization in Utah
Air sealing closes the gaps that let heated air leak out of a house and outside air leak in — top plates, can lights, chases, rim joists, hatches, and door and window trim. Grandview Contractors performs air sealing and weatherization across Utah County and Salt Lake County under a Utah DOPL B100 general contractor license, standalone or as the first step of any insulation project.

When air sealing is the job — and when it isn’t
Air sealing is the right scope when the house is drafty rather than under-insulated. The tells are specific: a cold stripe along the floor at exterior walls, a furnace that short-cycles on windy nights, gray dust streaks on attic insulation around light fixtures, frost under the roof sheathing in January. Those are air problems, and more insulation will not fix them.
If the attic is simply thin, the better value is sealing the ceiling plane and then adding material — our attic insulation and top-up service. If a rim joist or vaulted ceiling needs an air barrier and R-value in one pass, spray foam does both and standalone sealing is redundant there. If the walls are empty, dense-pack wall insulation tightens the cavity as a side effect of filling it. Standalone sealing earns its keep when the insulation is adequate but the house still feels drafty, or when a remodel has the ceiling or rim joist open and the sealing can be done with everything exposed.
Where Wasatch Front houses actually leak
Most leakage is not at the windows. It is at the top and bottom of the building, where the stack effect works: warm air escapes through the ceiling plane and replacement air gets pulled in at the foundation. A 50-degree gap between indoors and a January night on the bench drives that hard, and canyon wind events add direct pressure on top of it.
- Top plates of interior walls where drywall meets framing — a thin gap on every wall in the house.
- Recessed can lights, especially older non-IC fixtures that cannot be covered with insulation.
- Plumbing and flue chases, dropped soffits, the open bay above a tub.
- The attic hatch or pull-down stair, usually a quarter-inch gap around a plywood lid.
- Rim joists and the sill plate, where framing meets the foundation wall.
- Bath fan and dryer ducts, electrical and plumbing penetrations through exterior walls.

What the work involves
The materials are inexpensive; the labor is in finding the gaps and reaching them. The U.S. Department of Energy’s air-sealing guidance explains why the ceiling and foundation matter more than the windows.
- Diagnose. We walk the attic, basement, and rim joist with a smoke pencil or thermal camera on a cold or windy day and map where air is moving. When the scope justifies it, a blower-door test before and after gives a measured result rather than an opinion.
- Seal the attic plane. Top plates get a bead of sealant or one-part foam. Chases and dropped soffits get capped with rigid foam board, foamed at the edges. Can lights get airtight covers or sealed LED replacements. Flue penetrations get sheet metal and high-temperature sealant — foam is not allowed within clearance of a flue.
- Seal the bottom of the house. Rim joists get rigid foam blocks sealed at the perimeter or two-part closed-cell foam. The sill plate gets caulked. Duct boots, dryer vents, and pipe penetrations get mastic or sealant where they pass through the envelope.
- Weatherize the openings. Attic hatches get a gasket, a latch, and an insulated lid. Exterior doors get new weatherstripping and sweeps. Window trim gets backer rod and caulk where the old sealant has failed — at Utah’s elevation, UV breaks exterior sealant down faster than most labels assume.
- Check combustion safety. A tighter house changes how an atmospheric furnace or water heater draws air. We check for backdrafting after sealing and flag anything that needs an HVAC technician.
- Document. Photos of each sealed location and the before-and-after numbers when a blower door was used.

One Utah check rides along with every sealing job: this is high-radon geology, and a tighter house concentrates whatever seeps through the slab, so after sealing a basement or crawl space we recommend a radon test per EPA guidance.
What does air sealing cost in Utah?
As ballpark planning numbers, not quotes: sealing the attic plane of a typical single-story Wasatch Front home — top plates, chases, can lights, hatch — usually lands in the high hundreds to low thousands. A whole-house weatherization package that adds the rim joist, door weatherstripping, and exterior caulking generally runs into the low-to-mid thousands. A blower-door test adds a modest fixed cost.
What moves the number: whether existing insulation has to be pulled back to reach the plates, the count of can lights and chases, and whether the rim joist is open or finished behind drywall. On a finished house, access is most of the labor. For a larger efficiency project, our energy retrofit work packages sealing with insulation, mechanical, and window upgrades under one scope.
Questions we actually get
Can a house be sealed too tight?
It can, which is why combustion safety and ventilation are part of the scope. If a blower-door test shows the house is tighter than its natural air exchange needs, the fix is controlled ventilation — a bath fan on a timer or a dedicated fresh-air unit — not leaving the leaks in place. Leaky houses ventilate randomly; tight houses ventilate on purpose.
Do I need to seal before adding attic insulation?
Yes, and in that order. Blown-in insulation on top of unsealed top plates and can lights becomes a filter for the air passing through it — the gray dust streaks show up within a few winters. Sealing after the fact means digging the material back out. If you are already planning a top-up, we price sealing and insulation as one visit.
Will air sealing fix my ice dams?
Usually it is most of the fix. Ice dams form when warm attic air melts roof snow that refreezes at the cold eave. Sealing the ceiling plane cuts the heat reaching the attic; insulation and clear soffit baffles do the rest. On a bench lot with deeper snow, a sealed attic matters more than on the valley floor.
Tell us what you’re working on
We reply within a couple of hours during business hours — a day at most. You’ll get a straight read on scope, sequence, and budget before anyone commits to anything.