Power washing & surface prep
Power washing and surface prep is the wash-scrape-sand-prime sequence that decides whether exterior paint lasts three years or twelve. Grandview does it as the first phase of every repaint and as a standalone scope across Utah County and Salt Lake County, under a B100 general contractor license.

When prep is the scope, not just the first step
On a full exterior house repaint, prep is built into the price. This page is for the cases where it stands alone: a property manager who wants a chalky, mildewed building washed and spot-primed now and painted next season; an HOA in Saratoga Springs or Eagle Mountain that needs a wash and prep report on twenty units before deciding what to repaint; a homeowner who’ll paint the walls but not spend a weekend on a ladder scraping fascia.
Prep is also where a repaint gets honest. Washing strips the chalk that hides hairline cracks; scraping finds the soft fascia under loose paint. Rot or failed flashing gets repaired inside the same contract rather than primed over. Siding cupped past saving gets priced as a siding replacement instead. Good work should not require detective work.
What the work involves, in order
- Chalk and substrate check. A dark cloth rubbed across sun-facing walls rates the chalking; an awl probes trim, sills, and bottom siding courses. That sets the pressure, cleaner, and primer before anyone unrolls a hose.
- Wash at the right pressure. Fiber cement and stucco take roughly 1,500–2,000 psi with a 25- or 40-degree tip; wood siding and soft trim get lower pressure and more dwell time; vinyl gets a wide fan held well back so water never drives up behind the laps. Mildew on north walls gets a hypochlorite cleaner first. We wash top-down, wand angled down at lap joints, and stay off windows, electrical, and soffit vents.
- Dry time. Wood needs to read below about 15 percent moisture before primer; stucco and masonry take longer. Along the Wasatch Front that’s one to three dry days, and we meter it rather than guess.
- Scrape and sand. Loose paint gets scraped back to a sound edge and feathered so the new film doesn’t telegraph the old outline. Glossy intact paint gets a scuff sand for tooth.
- Repair, caulk, prime. Rotted fascia and trim replaced, nail heads set and filled, failed joints cut out and re-caulked with paintable elastomeric sealant, and every bare spot primed to match the substrate: alkali-resistant on stucco, stain-blocking on cedar and redwood, bonding primer on chalky or glossy surfaces.

Why Utah walls chalk faster than the can says
Most paint literature assumes sea-level sun. At the 4,300- to 5,000-foot elevations of Provo, Orem, Lehi, and the Salt Lake valley, UV is meaningfully stronger, and it breaks the binder out of an acrylic film years earlier on south and west exposures. The pigment left behind is chalk. Paint applied over chalk bonds to the chalk, not the wall, and peels in sheets by the second spring. That’s why the wash and the bonding primer matter more here than the can suggests.
Two other local factors shape the wash. Freeze–thaw cycling has opened more caulk joints and lap seams than a walk will show, so we treat every seam as a water entry and keep pressure conservative there. And hard Wasatch Front tap water leaves mineral spotting if a wall dries streaky in direct sun, so we rinse in shade order, one elevation at a time.
What’s different about prep on a pre-1978 home
Houses built before 1978 may carry lead-based paint under the newer coats, and dry scraping or sanding it uncontained is both a health problem and a legal one. On those homes the plan changes: wet methods, containment, HEPA vacuums, and a certified crew under the EPA’s Renovation, Repair and Painting rule. Older neighborhoods in Provo, Salt Lake City, Murray, and Springville have plenty of this housing stock. If yours qualifies, we tell you at the walk and the price reflects the extra steps. Please don’t take a pressure washer to flaking paint on one of these houses yourself.
What does power washing and paint prep cost in Utah?
A wash-only visit on a typical single-family home along the Wasatch Front usually runs $400–$900, driven by square footage, stories, and mildew treatment. Full prep — wash, scrape, sand, caulk, spot-prime — more often lands in the $1,500–$4,000 range, with heavy peeling, rot, and lead-safe work pushing it higher. These are ballpark planning numbers, not a quote; the firm estimate comes after we walk every elevation, from a contractor you can verify at dopl.utah.gov.
The biggest lever is the condition of the existing film. A chalky but intact wall is a wash and a bonding primer; a wall with 30 percent of the paint lifting is hours of scraping per elevation plus primer on every bare patch. After that: access, substrate (wood takes more scraping than fiber cement or stucco), and whether rot repair turns part of the job into carpentry. Decks are a different process with different numbers — see deck and fence staining and sealing.
Questions we actually get
How soon after power washing can a house be painted?
Usually one to three dry days along the Wasatch Front, longer for stucco and masonry or after a monsoon cloudburst. We meter wood and wait for it to read below about 15 percent. Painting over damp siding traps water under the new film and blisters it from behind.
Will power washing damage my siding or push water inside?
Not if the pressure, tip, and angle match the material. Too much pressure furs wood, etches stucco, and drives water up behind vinyl laps into the wall cavity. We use lower pressure with more cleaner and dwell time on soft or lapped surfaces and keep the wand angled down at every seam.
Can you just wash and prep so I can paint it myself?
Yes. We’ll wash, scrape, sand, caulk, and spot-prime the house and hand it back ready for topcoat, with a note on which primer we used so your paint is compatible. The exception is a pre-1978 home with suspected lead paint, where we’d want to handle the full sequence.
What drives the price of exterior prep up or down?
How much paint is failing, mostly. A chalky but intact wall is a wash and bonding primer; heavy peeling means hours of scraping per elevation. Stories and lot access, wood versus fiber cement or stucco, rot repair, and lead-safe containment are the other movers.
Where prep usually leads
Prep opens everything under our exterior painting service in the site, structure & envelope family. A washed and primed wall usually leads to a siding repaint, a breathable coat on stucco, or fresh trim and fascia paint. If washing shows the gutters have been dumping on the fascia, we fix that first.
Tell us what you’re working on
Send a few photos of the chalkiest wall, or just the address. We reply within a couple of hours during business hours — a day at most — with a straight read on what the surface needs.