Large-Format Tile Installation in Utah County
Large-format tile is porcelain or stone with any edge of 15 inches or more — 12×24 planks, 24×48 floor tile, and gauged porcelain panels up to 5×10 feet. Grandview Contractors installs it on floors, shower walls, and feature walls across Utah County under a Utah DOPL B100 general contractor license, with the floor flattened to the tolerance big tile demands.

When large-format tile is the right call
Choose large-format tile when you want fewer grout lines and a room that reads as one plane: open kitchen and great-room floors, curbless showers, tub-to-ceiling walls, and feature walls in a single marble-look panel. Less grout is also less to scrub.
It is the wrong call when the floor can’t be made flat enough, when the budget won’t stretch to the prep, or when the room is small and chopped up — a 24×48 tile in a 5×8 bathroom is mostly cuts. There, standard ceramic and porcelain floor tile in 12×12 or 18×18 gives the same durability with far more forgiveness. If the goal is a specific stone rather than a size, start with natural stone tile. Plank tile in herringbone or chevron is a custom tile pattern job, where layout rather than size drives the labor.
Why big tile has a tighter spec than small tile
A 12×12 tile follows a hump in the floor and nobody notices. A 24×48 tile bridges it, rocks, and leaves one corner proud of its neighbor — that raised edge is lippage, the defect large-format tile is known for. The industry standard for tile with any edge over 15 inches calls for a substrate flat to 1/8 inch in 10 feet and 1/16 inch in 2 feet, twice as strict as for small tile. Almost no existing Utah slab or plywood subfloor meets that. Flattening it is most of the job.
- Flatness mapping and correction. A 10-foot straightedge finds the highs and lows; we grind one and pour self-leveling underlayment over the other. A bouncy wood subfloor gets stiffened first; leveler doesn’t fix deflection. Bigger corrections run like our subfloor prep and leveling work.
- Uncoupling membrane over concrete. Most Utah County slabs sit on expansive clay or collapsible bench soil and carry cracks. A big tile spans a crack rigidly, so we set large format over an uncoupling membrane such as Schluter DITRA rather than directly on the slab.
- Large-and-heavy-tile mortar. Standard thinset slumps under a 24×48 tile and leaves voids. We use mortar rated for large and heavy tile, comb it in one direction, and back-butter every piece for 80% coverage in dry areas and 95% in showers. Hollow corners chip later.
- Offset and joint width. Rectangular tile is slightly bowed from firing, so a 50% brick stagger guarantees lippage. We lay plank and rectangular large format at a 33% offset or less, with joints no tighter than 3/16 inch.
- Leveling clips. Clips hold adjacent tiles in plane while mortar cures, then snap off. On a wavy floor they just lock the waviness in.

How a large-format tile install runs
- Measure the floor, not just the room. We straightedge the floor and tell you how much leveling it needs before you commit to a tile. On new builds in Lehi, Saratoga Springs, or Eagle Mountain, we also confirm the slab has cured — green concrete shrinks under tile set too early.
- Dry layout. Big tile shows cut widths plainly, so we lay it out on paper first: balanced cuts at both walls, no slivers at doorways, grout lines carried from floor up the shower wall.
- Prep and membrane. Grinding, leveler, membrane, and a day or more of cure before tile. Winter installs in unheated basements get space heat; leveler and mortar cure slowly below 50°F.
- Set with full coverage. Back-buttered tile, clips, a mallet, and a straightedge across every row. We pull a tile early to verify coverage rather than assume it.
- Grout, movement joints, walk-through. Soft joints at perimeters and every 20 to 25 feet in the field, silicone at plane changes, and a lippage check with you in raking light.
In a shower, waterproofing follows our shower tile installation approach; panels change the layout, not the membrane.
What large-format tile costs in Utah
As ballpark planning numbers, not a quote: large-format porcelain floor tile in Utah typically runs about $15–$35 per square foot installed, including setting materials, membrane, and routine leveling — roughly 30–50% above standard-size porcelain, almost all of it labor. A real estimate follows a straightedge on your floor.
- How far out of flat the floor is. A great room needing a quarter inch of leveler can add several dollars per square foot. This is the number that changes most between houses.
- Tile size. 12×24 sets fastest; 24×48 takes two people; panels take three. Jogs and doorways turn whole tiles into wet-saw cuts.
- Exterior use. 2 cm porcelain pavers on a patio or entry need frost-rated tile and exterior setting materials; the Wasatch Front sees roughly 100 or more freeze-thaw days a year, and pavers set without drainage heave the first winter.
Questions we actually get
Can large-format tile go directly on my existing concrete slab?
Rarely. Most Utah County slabs carry hairline cracks from clay-soil movement, and a big tile transmits that movement into itself. We flatten the slab, then set over an uncoupling membrane — a small line item next to replacing cracked 24×48 tile later.
Why won’t you lay 12×24 plank tile at a 50% offset?
Because rectangular tile is bowed slightly from the kiln, highest in the middle. A 50% stagger puts each tile’s high center against its neighbors’ low ends and creates lippage no clip can fix. A 33% offset or straight stack keeps the bows aligned; most manufacturers print this on the box.
How much does floor leveling add to a large-format tile job?
It depends on how far out of flat the floor is, which we measure before quoting. A floor within 1/4 inch over 10 feet may need only grinding and a skim coat. One an inch out needs bags of leveler and a day of cure, adding several dollars per square foot.
Can you tile a shower wall in a single porcelain panel?
Yes. Gauged porcelain panels up to 5×10 feet and 6 mm thick cover a shower wall with one or two joints instead of forty, over a tested waterproofing membrane. They need a rail cutter, a carry frame, and three people per piece, so handling, not material, sets the price.

Large-format tile is one option within our tile and stone installation work and most renovation projects. Our B100 license is verifiable at dopl.utah.gov.
Tell us what you’re working on
We reply within a couple of hours during business hours — a day at most. You’ll get a straight read on scope, sequence, and budget before anyone commits to anything.