Site, structure & envelope

Deck repair & restaining in Utah County

Deck repair fixes what is actually failing — a rotted ledger, a post on dirt, boards that splinter underfoot — and leaves the sound parts alone. Grandview inspects, repairs, reboards, and restains existing decks across Utah County under a B100 general contractor license, and says plainly when a repair stops making sense.

Discuss a project   Or call (385) 236-1741

Weathered wood deck with rustic chairs and table overlooking a lake, a surface due for stripping and restaining

Repair, reboard, or rebuild: what your deck actually needs

Three different problems get called “deck repair,” at very different prices. A repair is targeted structural work on a mostly sound deck: one rotted post, a nailed ledger, a few punky joists. A reboard keeps the frame and replaces the surface. A rebuild is for a frame that is done, and that belongs on our deck construction page.

The inspection decides which bucket you are in, and we do it with an awl and a moisture meter. Joists that take a probe more than a quarter inch, posts soft at grade, or a rim joist crumbling behind the ledger mean the frame is compromised. Gray, cupped boards on a dry, tight frame mean only the surface needs to go.

Reboarding also means choosing between a pressure-treated wood surface that wants stain every few years and a composite surface that asks for nothing after. If the only problem is a wobbly stair or a guard short of code, start with deck stairs and railings instead.

What structural deck repair involves

Repairs follow the load path from the house outward, because the parts that fail most often are the ones you cannot see.

  1. Open the ledger. We pull the first row of boards along the house and probe the rim joist; a nailed or unflashed ledger usually has rot behind it. The fix is a new ledger through-bolted into solid framing and flashed to shed water over the siding, with rim-joist repair first where the awl sinks.
  2. Sister or replace joists. A joist soft only at the ledger end gets a full-length sister bolted alongside; one rotted through gets replaced. Every top edge gets joist tape.
  3. Get posts off the dirt. Buried posts get cut and set on standoff bases over new footings below frost depth — commonly around 30 inches, verify with your city. Utah’s 100-plus freeze–thaw days a year heaved the old shallow footing and will heave it again.
  4. Replace mismatched hardware. Modern treated lumber corrodes plain-zinc connectors; anything we touch becomes hot-dip galvanized or stainless, and we photograph the ledger, flashing, and footings before boards cover them.
Close-up of a deck framing repair with a power drill, galvanized bracket, and safety gloves on the lumber

Reboarding: a new surface on a sound frame

Reboarding is the best value in deck work when the frame qualifies — and it has to qualify. Composite boards are less stiff than lumber; most lines want joists at 16 inches on center for straight runs and 12 for diagonals, and the manufacturer’s span table (Trex publishes theirs) is what the warranty rides on. A frame built at 24 inches gets intermediate joists first, and on bench lots in Alpine or Cedar Hills we check spans against the heavier snow those decks carry.

Old frames are rarely flat, so we string the joists and shim them first. Then joist tape, blocking at butt joints, hidden fasteners or color-matched screws, and new fascia and stair treads so the surface reads as one piece, not a patch.

Restaining a wood deck at Utah elevation

At 4,500 feet and up, UV does most of the damage to a wood deck. A south- or west-facing surface in Provo or Lehi grays out in a season or two without a finish, and the gray is surface fibers breaking down. Restaining is as much prep as finish: strip any peeling film-forming coat, clean and brighten so the grain opens, then wait for the wood to dry below roughly 15 percent moisture — not the week after a July monsoon cloudburst.

Stain wants a surface temperature of roughly 50 to 90 degrees and no direct sun, so spring and fall beat high-summer afternoons. Penetrating oil stains wear away instead of peeling and are our default on older decks; semi-transparent needs recoating every two to three years at this elevation; solid stain hides tired boards but fails like paint.

Freshly stained wood deck with autumn leaves, the even finish that comes from stripping and brightening first

What does deck repair cost in Utah County?

As ballpark planning numbers, not quotes: restaining, including stripping and brightening, typically runs about $2–$5 per square foot in our market. Reboarding over a sound frame lands roughly $15–$30 per square foot in pressure-treated wood and $25–$50 in composite, including fascia and treads. Structural repairs are priced by the item — a new bolted and flashed ledger is commonly a low-four-figure job, and each post reset on a below-frost footing adds several hundred dollars or more.

  • How much frame survives. Reboarding is a bargain; reboarding plus sistering half the joists is not.
  • Rot behind the ledger. Means opening siding and repairing house framing first.
  • Railing. A guard under 36 inches gets replaced with the surface, and that system moves the number more than the boards do.

You get a budget range after the site walk, then a firm estimate once selections are made. Every project runs under a license you can check at Utah DOPL, and related site, structure and envelope work can run under the same contract.

Questions we actually get

How do I know whether my deck needs repair or a full rebuild?

Probe the frame, not the boards. Soft joists, posts mushy at grade, a nailed ledger with rot behind it, or heaved footings point to a rebuild. Weathered boards on a dry, tight frame point to reboarding or restaining. We inspect before quoting and show you what we found.

Can I put composite boards on my existing wood frame?

Usually, with conditions. The frame has to be sound and joist spacing has to match the manufacturer’s span table — typically 16 inches on center, 12 for diagonals. Frames built at 24 inches get added joists first, plus joist tape and fresh hardware.

Do I need a permit for deck repair in Utah?

Restaining and like-for-like board replacement generally do not. Replacing a ledger, adding footings, changing the railing, or enlarging the deck usually does, and thresholds vary by city. We pull the permit when the scope calls for it; verify specifics with your city’s building department.

What drives deck repair cost the most?

The condition of the ledger and the house framing behind it, then how many joists and posts need replacing. Composite costs more than wood to reboard, a new railing can cost more than the boards, and stripping a heavily layered old finish adds labor to restaining.

Tell us what your deck is doing

We reply within a couple of hours during business hours — a day at most. You’ll get a straight read on whether it is a repair, a reboard, or a rebuild before anyone commits to anything.

Request an estimate   (385) 236-1741