Renovation & Build-Outs · Interior Painting

Trim & door painting in Salt Lake City

Trim and door painting is the enamel work — baseboards, casings, crown, jambs, and interior doors — done as its own scope with the walls masked off. Grandview Contractors handles it across Salt Lake City under a Utah DOPL B100 general contractor license, including the oak-to-white conversions most homes built between 1985 and 2010 eventually ask for.

Discuss a project   Or call (385) 236-1741

Paint roller resting on a stepladder beside a wall masked off for trim and door painting
Who this is for

When trim-only is the right scope

Hire this scope when the walls are fine and the woodwork is not: honey-oak casings and six-panel doors that date the house, white trim yellowed by aging oil enamel, baseboards chipped by a decade of vacuums, or new millwork that arrived primed and needs finish coats. It’s also the scope for a door color change — charcoal doors against white casings is a small job with a large effect.

If the walls need color too, the better fit is single-room painting or a whole-home repaint, where trim is folded into the sequence and priced with the walls. Kitchen and bath boxes live under cabinet painting; the weather side of an entry door belongs with exterior door refinishing. This page is the inside of the house, enamel only.

Process

What trim and door painting involves

  1. Pull hardware and doors. Hinges, knobs, and strikes come off rather than getting taped around. Each door is numbered on its hinge mortise so it returns to the same opening once cured.
  2. Degloss and fill. Every surface is scuff-sanded so the enamel can bite. Nail holes get filled, cracked caulk cut out, and casing-to-wall joints recaulked with paintable acrylic — never silicone, which paint won’t hold to.
  3. Prime for the substrate. Painted trim takes a bonding primer. Stained wood takes a stain-blocking primer, because oak and fir tannins bleed through ordinary primer and surface as tan streaks weeks later.
  4. Spray the doors flat. Doors go horizontal on racks, usually in a masked garage booth, so the enamel levels without runs at the panel edges. Jambs and stops are sprayed in place, walls papered off.
  5. Brush the running trim. Baseboards, casings, and crown get two coats of waterborne alkyd or urethane trim enamel in satin or semi-gloss — hybrids that cure hard like old oil paint without yellowing the way oil does.
Close-up of a paint roller and tray staged for enamel work on interior trim
The Salt Lake question

Painting stained oak trim white without regret

Most trim questions from Sandy, West Jordan, Draper, and the Salt Lake bench are the same job: golden-oak casings and doors from the 1990s build-out, and whether they can go white. They can. Two decisions made before the first coat decide the result.

The first is grain. Oak’s open grain telegraphs through any number of coats. A smooth, furniture-grade surface needs grain filler before primer, which roughly doubles the prep hours; a visible wood texture under white enamel skips that step and costs less. We’ll show you both on a sample door.

The second is timing. Forced-air heat often pulls a Salt Lake house below 20 percent humidity in winter, and wood trim shrinks, opening miters and the caulk line along the wall. Caulking in a dry month closes the joints at their widest so they stay closed through summer; caulking in July means a hairline may open by January. That decides the caulk we spec and whether to expect a touch-up.

In Sugar House, the Avenues, Liberty Wells, and Rose Park, most painted trim predates 1978, and federal rules require lead-safe work practices when sanding or disturbing it. If your house is from that era, we’ll talk through the prep before anyone picks up a sander.

Budget

What does trim and door painting cost in Salt Lake City?

As ballpark planning numbers: brushed baseboard and casing typically runs $1.50 to $4 per linear foot along the Wasatch Front, and an interior door with jamb lands roughly $125 to $300 pulled and sprayed, less brushed in place. Converting stained oak adds blocking primer and sanding, so expect the top of those ranges. A written estimate follows a walk-through.

What moves the number: door count and whether any are paneled, crown and stair skirts that need ladder work, grain filling, failed caulk to cut out, and whether the home is occupied. Trim costs more per surface than walls because it’s nearly all brushwork; there is no roller shortcut on a six-panel door.

Sequence matters too. If new flooring is coming, we finish the base after the floor goes in so shoe molding gets painted with it. If new casings or crown from a trim and millwork install are in the plan, we prime them before they go up and finish after, which saves a coat.

Empty room with hardwood floors and neutral walls where new baseboards meet the finished floor

Questions we actually get

Can oak trim be painted white without the color bleeding through?

Yes, if it’s primed with a stain-blocking primer first. Oak and fir tannins migrate through latex primer and show as yellow-brown streaks months later; a shellac-based or oil-based blocking primer stops that. The grain still shows unless it’s filled, a separate choice we’ll sample before quoting.

Should doors be sprayed or brushed?

Sprayed when they can be pulled and laid flat — no brush marks, and the enamel levels evenly across the panels. Brushed when a door can’t come off, or when only a few doors are in scope and the spray setup isn’t worth it. Either way, jambs are finished in place and walls are masked, not painted around.

Should trim be painted before or after new floors?

After the floor goes in, so baseboard and shoe molding get their finish coats together and the floor joint is caulked once. If flooring is weeks away, we’ll prime now and finish behind the installer. Doors and casings don’t depend on the floor and can be done any time.

How long until I can close the doors and use the trim normally?

Hybrid trim enamels are dry to the touch in hours but take roughly a week to fully cure, and that’s when doors can stick in their jambs. We rehang doors after the first day and leave them cracked, and we’ll tell you when to go easy on the baseboards with furniture.

Related services

Trim and door painting sits inside our interior painting service, part of the renovation and build-out family. Our license is verifiable at dopl.utah.gov.

Tell us what you’re working on

We reply within a couple of hours during business hours — a day at most. You’ll get a straight read on scope, sequence, and budget before anyone commits to anything.

Request an estimate   (385) 236-1741