Wallpaper Removal & Prep in Utah County
Wallpaper removal is stripping paper, vinyl, and borders to bare wall, washing off the adhesive, then repairing and priming the surface so new paint doesn’t show where the paper used to be. Grandview Contractors removes wallpaper and preps the walls behind it in homes, rentals, and small commercial spaces across Utah County and Salt Lake County under a Utah DOPL B100 general contractor license.

When wallpaper removal is its own job, not a line in a paint bid
A single-room repaint assumes the walls are sound and only need patching; a whole-home repaint assumes the same in every room. Wallpaper breaks that assumption. Until the paper and paste are gone, nobody knows what the wall underneath looks like, and no honest painter can price the finish.
The common Wasatch Front cases: vinyl borders in homes built from the late 1980s through the mid-2000s; full-wall paper in powder rooms and dining rooms; paper hung on unprimed builder drywall, which tears the drywall face on the way down; and paper painted over years ago, the hardest kind because the paint seals it against the water that would release it.
Two scopes sit next door. If the wall behind the paper is gouged or the texture no longer matches, the fix is a skim coat, scoped with the removal as one job. If a papered feature wall is becoming a bold color, the prep here leads straight into accent wall painting.
How we take wallpaper off without taking the wall with it
- Identify the paper and what it’s stuck to. We lift a corner behind a door. Strippable vinyl peels in sheets and leaves a backing; traditional paper has to be soaked. If the drywall face comes up with the corner, the paper went onto unprimed board, and we plan the skim coat from the start instead of discovering it on the third wall.
- Score, soak, wait. Vinyl and painted-over paper get perforated so water can reach the adhesive, then warm water with a removal enzyme, or a steamer, and patience. Utah’s dry air works against this step: a wall that would stay wet twenty minutes at sea level can flash dry here in ten, so we soak small sections and re-wet rather than race the wall.
- Strip the layers. Top layer first, backing second, with wide flexible scrapers held low to the wall. Steep scraper angles are how walls get gouged.
- Wash the paste. The step most repaints skip. Wheat and clay pastes leave a film that looks like a clean wall and then makes new paint crackle, bubble, or shed in sheets. We sponge every wall with clean water, change it often, and check by hand: a wall with paste on it still feels tacky once dry.
- Seal, repair, prime. Torn paper faces get a penetrating sealer so compound dries evenly instead of bubbling. Gouges are filled, and the settlement cracks the paper was hiding, routine on the expansive clay and bench soils around here, get taped rather than filled. Then a bonding primer over the whole wall, because paste residue and bare compound take paint at different rates and flash under sheen.

If the home was built before 1978 and the paper was hung over painted walls, we test that paint before any sanding. Federal lead-safe practices apply to disturbing painted surfaces in those homes; the EPA’s RRP program sets out what that means.
What does wallpaper removal cost in Utah?
As a ballpark planning number, wallpaper removal along the Wasatch Front usually runs about $1 to $3 per square foot of wall area for stripping and washing: a 12-by-12 bedroom with one layer of strippable vinyl lands in the low hundreds, while a papered dining room or two-story entry climbs toward a thousand or more. Painted-over paper, multiple layers, and paper on unprimed drywall push toward the top of that range. A skim coat, where needed, and the repaint are priced on top. We confirm the number in writing after a walk-through and a test corner.
What moves the price: the number of layers, vinyl versus porous paper, whether it was ever painted, wall height and stairwells, and how much drywall face tears during removal. A single kitchen border is a short morning. A powder room with three decades of layered paper can be a full day of scraping before anyone washes a wall.

Questions we actually get
Can you just paint over the wallpaper instead?
Sometimes, and we’ll say so when it’s the honest answer. Tight, well-adhered paper can be sealed with an oil or shellac primer, seams filled, and painted. But that locks the paper in and makes the next removal the hardest kind, and in Utah’s dry interiors vinyl seams tend to lift and telegraph through paint. If the paper is loose anywhere, removal is the fix that lasts.
Why did the drywall tear when I tried to strip it myself?
Almost certainly the paper was hung on unprimed drywall. Builder-grade Utah County homes from the 1990s and 2000s often got borders and paper straight on bare board, so the paste bonded to the drywall’s paper face instead of a primer. When the wallpaper lets go, the face comes with it. The repair is a sealer over the tears and a skim coat, priced with the removal.
How long does wallpaper removal take, and do we need to leave?
One room with a single layer of strippable vinyl is usually a day including the wash and primer, then drying time before paint. Painted-over or multi-layer paper can double that. You don’t need to leave: the work is wet, not dusty, and we mask floors and outlets and dry the room each night. Occupied homes are the normal case.
Do you also do the painting afterward, or just the removal?
Either. Most clients want the room painted once the paper is gone, and running removal, repair, primer, and finish coats as one scope means nobody argues later about whose prep caused a problem. If you only need the paper off and the walls primed for your own painter, we’ll do that and leave the walls ready.
Related services
Wallpaper removal is a niche scope inside our interior painting service, part of the renovation and build-out family. When the wall underneath is damaged beyond a skim, it becomes a drywall repair job first. Our license is verifiable at dopl.utah.gov. Good work should not require detective work.
Tell us what you’re working on
We reply within a couple of hours during business hours — a day at most. You’ll get a straight read on scope, sequence, and budget before anyone commits to anything.